Kitchen Remodeling in Safety Harbor, FL

Philippe Park, Old Tampa Bay and the Drive Up From Sarasota

Our route crosses the Skyway, runs north on I-275 past St. Petersburg, and finishes along the bayfront that runs up to Philippe Park. Downtown streets are narrow and shaded by big oaks, so we stage deliveries with smaller loads when needed. We also serve Oldsmar and Palm Harbor. If you are deciding what to do with a family piece, our guide on whether to restore or replace heirloom furniture walks through the judgment calls.

Philippe Park, at 2525 Philippe Parkway, is the oldest park in Pinellas County: 92 bayfront acres around the Tocobaga temple mound, the largest remaining mound in the Tampa Bay region. Main Street runs east until it ends at the Safety Harbor Resort & Spa on the water, and the brick building at 200 Main Street, the town's first town hall, is the oldest on the street. The blocks around them are where we expect bungalow kitchens that need scribed, period-minded cabinets; the 1980s subdivisions farther from the bay are where a full builder-kitchen replacement usually makes more sense. Permits split two ways here: under a 2021 interlocal agreement, the City of Safety Harbor checks plans against its land development code at City Hall, 750 Main Street, and Pinellas County reviews and inspects for the Florida Building Code.

Get directions to the Lewis Ave shopRead customer reviews

Main Street Bungalows, Bayfront Humidity and 1980s Subdivisions

The historic core around Main Street, near the Safety Harbor Resort & Spa and its mineral springs, holds early twentieth-century bungalows and cottages: wood floors over crawl spaces, plaster or board walls, and kitchens enlarged piecemeal over the decades. Walls are rarely plumb, so cabinets need scribed fillers and site-fitted trim. Beyond downtown, 1980s subdivisions of block homes have builder kitchens with oak cathedral doors and laminate tops that are ready for a full replacement. Near the bay, sea breeze and summer humidity move solid wood seasonally, which is why we finish all six sides of panels and leave room for movement in door construction. The town of 17,072 (2020 Census) cares about its character, and kitchens that look original to an old house tend to read better here than a flat-slab reset.

Safety Harbor took its present name when it incorporated in 1917; before that the settlement was Green Springs. A fire on September 2 of that first year swept much of downtown, and the Hotel Frances was one of the few buildings left standing, so Main Street's look comes largely from the rebuilding that followed. In the older houses on the side streets, floors framed over crawl spaces are rarely level. We set base cabinets on adjustable levelers and shims rather than trusting the floor, and if a heavy stone top will land over a long joist span, we ask a licensed contractor to look at the framing before we build.

What Happens Between the First Measure and Install Day

We start with one thorough site visit: measurements, wall and floor checks with a level, and photos of trim profiles worth matching. Working drawings and a 3D rendering come next; you can review the model remotely or stop by our Sarasota shop by appointment to look at joinery and species side by side. Building happens entirely in our shop, with dovetail drawers and mortise-and-tenon face frames, and installation is booked as one continuous block of days. Any plumbing, wiring or wall work goes to licensed trades under the permit required for your address.