Skip to content
SRQ Woodworks Co. logo
Kitchen at the cabinet refacing vs replacement crossroads with one refaced run beside dated original cabinets

Cabinet Refacing

Cabinet Refacing vs. Replacement

The choice between refacing and replacing cabinets comes down to three questions about what is behind the doors. Answer them honestly and the decision usually makes itself.

By SRQ Woodworks Co. · Published

In the cabinet refacing vs replacement decision, the boxes cast the deciding vote. If they are dry, square and built from solid wood or plywood, and the layout already works, refacing gives you a new-looking kitchen while keeping everything that still functions. If water has softened them, or the room needs a different shape, replacement is the honest answer.

We make both calls regularly, sometimes in the same kitchen. Below is the way we work through it on a measure visit, laid out so you can run the same checks yourself before anyone comes to the house.

Three questions that settle the decision

Work through these in order. A clear no on any of the first two usually points to replacement; the third decides how much of the kitchen you can keep.

  1. Are the boxes structurally sound? Open each cabinet. Look for sides that have swollen at the bottom edge, shelves that sag, backs that have pulled away, and face frames that rock when you push them. Press down on the sink-base floor with your palm.
  2. Does the layout work the way you cook? Note where you wish you had counter space, where two people collide, and whether the fridge, sink and range sit in a sensible triangle. Refacing keeps every box where it is.
  3. Has water ever been in the cabinets? Think back to past leaks, a dishwasher failure, a roof drip or storm water. Stains, a musty smell or a soft spot are the evidence.

Two yeses and a clean water history make refacing the strong favorite. A failed answer on box condition, limited to one or two cabinets, can still lead to refacing with those boxes rebuilt.

Plywood, particleboard or MDF? Read an exposed edge

You can identify box material without taking anything apart. Find a raw edge: the cut-out for the sink drain, the bottom edge of a side behind the toe kick, or the rim of a shelf-pin hole. Plywood shows thin layers stacked like the pages of a book. Particleboard shows a coarse mass of glued chips, and MDF shows a smooth, dense brown with no grain at all. Staples holding a thin back panel and a printed wood-look paper on the inside faces are both signs of a builder-grade particleboard box.

Plywood and solid wood boxes hold hinge screws for decades and take new veneer well. Dry particleboard can be refaced, but expect it to be the limit on how long the refaced kitchen lasts. When the boxes pass and the frames still look good, cabinet door replacement on its own may be all the kitchen needs.

Flashlight inspection of a sink base cabinet floor and side panels to judge refacing or replacement
A flashlight beam across the floor and lower sides of an emptied sink-base cabinet.

Refacing vs replacement, side by side

Once you know the condition of the boxes, compare what each route delivers. The table focuses on outcomes rather than price; for the money side, see our breakdown of cabinet refacing cost vs. new cabinets.

What changes with each approach
QuestionRefacingReplacement
Can the door style and color change?Yes, completelyYes, completely
Can cabinets move or change size?No, apart from rebuilding a box in placeYes
Can drawers replace doors?Often, inside the existing boxYes, planned from scratch
Do countertops come off?Usually notYes
Are licensed trades involved?RarelyUsually a licensed plumber, often a licensed electrician
Does a permit apply?Typically not for fronts aloneDepends on plumbing, wiring or wall changes
How long is the kitchen out of use?Days of on-site workA longer multi-trade sequence

Our cabinet refacing service page explains how veneer, overlay and door style are chosen once refacing is the path.

When does water damage rule out refacing?

Water is the most common reason a kitchen that looks like a refacing candidate turns into a replacement. Particleboard and fiberboard swell when wet and do not shrink back; the screws that hold hinges lose their grip, and the box can no longer carry new doors safely.

Timing matters too. The EPA advises that damp materials dried within 24 to 48 hours of a leak or spill will, in most cases, not grow mold. A slow drip under a sink can go unnoticed for months, which is why the sink base is where we look first. Hidden mold behind a cabinet back is not something to cover with new fronts.

Does a flood zone change the math?

For homes in a mapped flood zone, the scope of the cabinet work can matter for reasons beyond the kitchen. The National Flood Insurance Program defines a substantial improvement in 44 CFR 59.1 as any reconstruction, rehabilitation or other improvement costing 50 percent or more of the structure's market value before construction starts. A building that crosses that line has to be brought up to the community's current floodplain requirements, which for an older slab-on-grade house can mean elevation.

FEMA's Substantial Improvement/Substantial Damage Desk Reference lists built-in kitchen cabinets, plumbing fixtures and piping, interior finish carpentry, and contractor overhead and profit among the costs that count toward the percentage. A full replacement stacks up several of those lines at once. Refacing touches far fewer of them, because the boxes stay in place and the counters, sink and supply lines stay connected.

  • Ask the building department that covers your address how it values the structure and which kitchen costs it counts.
  • Ask whether other permitted work on the house, such as storm repairs or a new bath, is reviewed together with the kitchen.
  • Get the cabinet scope in writing early, so the improvement figure is known before you settle on refacing or replacement.

This question comes up most along the Manatee River in Bradenton and in low-lying neighborhoods near Sarasota Bay. Only the floodplain administrator can make the determination; our part is to give you a clear written scope for each option.

Flashlight on the swollen bottom edge of a sink base cabinet in a low-lying Florida kitchen
A flashlight beam on the toe-kick edge of a sink base, showing a darker swollen band at the bottom of the side panel.

Can refacing fix a layout you dislike?

Partly. Refacing cannot move a sink or shift a wall, but it can change how the existing boxes work. A door-and-shelf base can become three deep drawers. A blind corner can get a pull-out. An upper beside the range can turn into an open spice niche. Swapping the over-fridge cabinet for a deeper one is possible if the space allows.

What refacing cannot do is add an island, close up a dead corner, or raise the uppers to the ceiling. If those are on your list, you are describing a new kitchen, and replacing the cabinets will feel like money well spent.

Base cabinet converted from a door and shelf into three dovetailed drawers during refacing
Three new drawers fitted into an existing base cabinet where a door and shelf used to be.

How the age of a Sarasota or Bradenton home tilts the choice

Housing era often predicts what we will find. In Sarasota, Sarasota School mid-century homes and older bungalows sometimes still hold site-built cabinets with solid wood frames that reface beautifully, provided the layout suits modern appliances. Many 1970s and 1980s subdivisions around Bradenton were fitted with builder cabinets whose boxes vary widely: some sturdy, some particleboard that has seen a few dishwasher leaks.

Older homes add one more step. For houses older than 1978, federal lead rules from the EPA call for lead-safe practices whenever hired workers disturb painted surfaces, and tearing out painted cabinets counts just as sanding them does.

Mid-century Sarasota style kitchen with original flat-panel wood cabinets under clerestory windows
Flat-panel wood cabinets in a low-slung mid-century kitchen lit by high clerestory windows.

The bottom line

Refacing or replacement is less a matter of taste than of what the boxes, the layout and the water history allow. Run the three questions, look under the sink, and the direction usually becomes clear. For a definite answer on your own kitchen, phone us or write through the contact form to book a measure; by the end of that visit you will know which cabinets stay and which ones go.

Sources

  1. U.S. EPA — A Brief Guide to Mold, Moisture and Your Home
  2. U.S. EPA — Lead Renovation, Repair and Painting Program
  3. 44 CFR 59.1 — Definitions, substantial improvement (Cornell LII)
  4. FEMA P-758 — Substantial Improvement/Substantial Damage Desk Reference, May 2010, Section 4.4.1 (copy hosted by Utah Division of Emergency Management)

FAQ

Frequently asked questions

Can refaced and new cabinets be mixed in one kitchen?

Yes, and it is common. We reface the sound runs and build new boxes where the layout or water damage calls for it, such as a fresh sink base or a new pantry tower. Because both the veneer and the new boxes are finished in the same booth at the Lewis Ave shop, the colors and sheen match across the room.

Does refacing hurt resale compared with new cabinets?

Buyers judge what they see and how drawers and doors work. Refaced solid-wood fronts on sound boxes read as an updated kitchen. Where refacing falls short is an awkward layout or weak boxes, which a buyer will notice either way. In Sarasota and Bradenton homes we suggest putting the money where those weaknesses are.

Is it worth refacing cabinets that are 30 years old?

Yes, if the boxes are solid wood or plywood and have stayed dry. Age alone does not rule refacing out; many older site-built cabinets are sturdier than newer builder boxes. What matters is whether hinge screws still bite, shelves sit flat and the sink base is firm. Particleboard of that age has usually met a leak or two, so we check it box by box at the measure.

Do I need a permit to replace kitchen cabinets?

It depends on what else changes. New fronts alone typically need no permit. When replacement moves a sink, adds circuits or opens a wall, that work is done by licensed trades who pull permits through the building department for your address, such as the City of Sarasota, the City of Bradenton or the county. We plan the cabinet drawings around their rough-in.

Living Well Crafted

Planning cabinet refacing? Talk it through with the shop.

  • Built in our Sarasota shop since 2011
  • 4.4★ from 52 Google reviews
  • 3D model before anything is built
  • Solid-wood boxes, dovetail drawers
SRQ Woodworks Co. · 1121 Lewis Ave, Sarasota, FL 34237 · Monday – Saturday 8:00 am – 6:30 pm · Sunday Closed · Shop visits are by appointment. Please call ahead before stopping by Lewis Ave.
Call (239) 545-0550Get a Quote